Smallbobrob - New Release: Spooky Winnie the Pooh Clickers!
More from Smallbobrob
Smallbobrob - Highland Cow PocketBac Holder
About This Title
Halloween Winnie the Pooh Clickers!
This spooky collection features four of your favorites hanging out inside honey jars dressed up in their Halloween costumes: Pooh, Tigger, Roo, and Eeyore!
Note: Eeyore is actually on my printer right now finishing up his test run, but the files are 100% complete and ready for you on the slicer. I wanted to get these out to you immediately so you can jump right into the Creative Challenge!
Printing & Assembly Tips:
Print in Bulk (Multi-Part Multiplier) : I highly suggest printing these more than one at a time. During my testing, whenever I printed just a single clicker by itself, I ran into sizing bugs where the clicker piece fit way too loosely inside the base mechanism. However, whenever I printed them in bulk batches, that issue completely disappeared and the tolerances were spot on!
Tigger Assembly Trick : To prevent the mechanical clicking feature from getting permanently stuck, use this specific assembly order:
Slide the blank clicker piece into the HUNNY jar base first.
Once the clicker is seated, snap Tigger directly onto the clicker stem itself.
The STL and sliced plates are officially live! Grab the files below, get your test prints ready, and remember to enter your most creative photos into our Monthly Print Challenge Chat before September 28th!
Happy printing!
Halloween Winnie the Pooh Clickers!
This spooky collection features four of your favorites hanging out inside honey jars dressed up in their Halloween costumes: Pooh, Tigger, Roo, and Eeyore!
Note: Eeyore is actually on my printer right now finishing up his test run, but the files are 100% complete and ready for you on the slicer. I wanted to get these out to you immediately so you can jump right into the Creative Challenge!
Printing & Assembly Tips:
Print in Bulk (Multi-Part Multiplier) : I highly suggest printing these more than one at a time. During my testing, whenever I printed just a single clicker by itself, I ran into sizing bugs where the clicker piece fit way too loosely inside the base mechanism. However, whenever I printed them in bulk batches, that issue completely disappeared and the tolerances were spot on!
Tigger Assembly Trick : To prevent the mechanical clicking feature from getting permanently stuck, use this specific assembly order:
Slide the blank clicker piece into the HUNNY jar base first.
Once the clicker is seated, snap Tigger directly onto the clicker stem itself.
The STL and sliced plates are officially live! Grab the files below, get your test prints ready, and remember to enter your most creative photos into our Monthly Print Challenge Chat before September 28th!
Happy printing!
Comments (0)